KTM/Husqvarna Conrod from Crankworx – Crankworx have taken their manufacturing processes of their high performance Rod conrod to the next level in durability & strength.

The Crankworx Rod has been designed specifically for use in stock, high modified or big bore engines for the pro racer to the everyday trail rider. When properly installed the Crankworx Rod will perform flawlessly in the highest powered engine at the highest level of the sport.

Crankworx Rod a true performance racing conrod - being manufactured from double forgings resulting in the correct grain flow for strength, shotpeen to relive stress, magnafluxed at least twice to check for imperfections and Rockwell tested to validate hardness. Bearings running surfaces are round to 50 millionths and double hone to a mirror finish. 

Motoxparts can fit and balance this rod to your crank for a low cost - 98% of motorbike crankshafts are rebuildable. Installing a conrod crankshaft rebuild will take the important working areas of the crankshaft back to new specifications . More information about this service can be found in the "Engine" category under "Crankshaft & Bearings".

• Meets genuine specifications
• Conrod kit includes: Conrod, crankshaft/conrod main big end pin, conrod center big end bearing, set of thrust washers
• Manufactured from true forgings resulting in the proper grain flow
• Each part is double magnafluxed
• Double top bearing oil holes in rod - this provides more needed oil to the highest load area – piston pin & top end bearing
• Rockwell tested to validate the correct hardness
• Conrod is shotpeen to relive stress
• Image is generic and may differ slightly to part supplied.